BlueROV2 Enclosure Only

154,227.00

Pre-wired and tested with all of the BlueROV2 electronics, this enclosure is ready-to-integrate into your custom ROV frame or other application.

Available on backorder

SKU: BROV2-ASM-ELEC-ENCLOSURE-R1-RP Category:

Product Description

This product includes the enclosure and electronics from the BlueROV2, pre-wired and ready to go! This is an excellent option if you are building a custom ROV frame and need a ready to use electronics and control solution!

Contents

4″ Series Enclosure

  • 1 x Extruded Acrylic Tube – 11.75″, 298mm (4″ Series)
  • 2 x O-Ring Flange (4″ Series)
  • 1 x Dome End Cap (4″ Series)
  • 1 x Aluminum End Cap with 14 Holes (4″ Series)
  • 1 x Enclosure Vent and Plug

Advanced Electronics

  • 1 x Raspberry Pi 3 Model B Computer
  • 1 x Low-Light HD USB Camera
  • 1 x Single Fathom-X board
  • 1 x ArduSub Raspbian MicroSD Card (16GB)
  • 1 x 5V 6A Power Supply
  • 1 x Pixhawk Autopilot
  • 1 x Pixhawk Shelf and Mounting Hardware
  • 1 x 6″ Left-Angle Micro USB Cable for Raspberry Pi to Pixhawk
  • 1 x Blue Robotics Power Sense Module
  • 1 x XT60 Female to Bullet Connector Cable (for Pixhawk Power Module)
  • 1 x Ferrule to Spade Cable (for Fathom-X)

Electronics Tray

  • 1 x Electronics Tray (4″ Series) (with Terminal Blocks and Hardware)
  • 1 x Camera Tilt System (with Mount for USB Camera)

Other

  • 6 x Basic ESC (new R3 version)
  • 3 x Blank Penetrators
  • 1 x Bar30 High-Resolution 300m Depth/Pressure Sensor
  • 1 x BlueROV2 Power Cable